Troubleshooting Guide - Brita WHS - 201 Instrucciones De Instalación

whole house filtration system
Test the Filter System
• Slowly turn on water supply.
• Press red pressure-relief button to
release any trapped air.
• Check for leaks.
• Turn on the nearest faucet and flush
system for 40 minutes.
10
Step 4
*
*
*
*
*
*
*
*
*
*
*
*
*
» If leaks continue, turn off the water supply and call
Customer Service or your local plumber.
whole house filtration system
Troubleshooting
Guide
Leaks between system
head assembly and
filter housing
Note: Place paper towels or rag under the filter
system to catch any water drips.
Turn off main water supply to home.
Purge water from lines by turning on all faucets
and drain lines completely.
Press red pressure-relief button on system
head to release pressure.
Unscrew and remove system head using filter
housing wrench.
Remove black o-ring and inspect. Clean and
lubricate with silicone grease.
Clean grooves in top of filter housing where the
o-ring sits.
Place the clean, lubricated o-ring back in the
groove.
Screw filter housing back onto the system head
and hand-tighten. DO NOT OVERTIGHTEN.
Leaks around fittings
Turn off the main water supply.
Purge water from plumbing lines by turning on
all faucets in your home and draining completely.
Tighten all fittings.
Turn on the main water supply, and inspect for
leaks.
If leaks continue, disassemble the configured
system, reapply plumber's tape or sealant, and
reinstall the filter system.