MP6025647-2AF1 / A
Charger
The transmitter contains a non-replaceable, rechargeable battery that you can recharge
as needed with the charger. The charger has a green light that shows the charging status
and a red light that communicates any problems during charging. If you see a red light,
see the Troubleshooting section. The charger needs one AAA alkaline battery, size E92,
type LR03 (Energizer brand recommended) to operate.
Note: A new AAA or LR-03 battery contains enough power to recharge the transmitter
more than 40 times. If the battery is installed incorrectly or is low, the charger will
not work. Repeat the battery installation steps using a new battery.
Installing a battery in the blue charger
1
Remove the charger battery cap by turning it counter-clockwise
1/4 turn using a coin in the groove of the cap.
2
Insert a new AAA or LR-03 battery with the flat (-) end first.
Make sure that you align the small bumps on the battery cap
with the small notches in the charger's battery opening. Push in
the cap all the way using a coin. Turn the cap clockwise 1/4
turn to close.
Charging the transmitter
Before using the transmitter for the first time, you must fully charge the transmitter
battery. This may take up to eight hours. It is recommended to recharge the transmitter
after each sensor use. If you choose to recharge the MiniLink after a 6-day sensor use,
the charging time will be less than 20 minutes. A fully charged transmitter battery works
more than 14 days without recharging. After 14 days of use, the transmitter recharges in
less than two hours.
To charge the transmitter:
1
If a green light on the transmitter is lit or flashing, do not
connect it to the charger. The transmitter will not charge with its
green light on. Wait until the green light turns off (approximately
30 seconds), and then connect the transmitter to the charger.
2
Connect the transmitter to the charger by lining it up, flat side
down, with the charger. Push the two components together
fully.
-4-