Publicidad
Step 6
First, fi ll the hole in the short edge of the UPRIGHT (C3) 1/4 to 1/2
å
full with GLUE (54M). Then, insert a WOOD DOWEL (15F) into the
hole. Wipe away the excess GLUE.
Next, fi ll the two holes in the other short edge of the UPRIGHT (C3)
å
1/4 to 1/2 full with GLUE. Then, insert two WOOD DOWELS (15F)
into these holes. Wipe away the excess GLUE.
Now, fi ll the holes in the BACK PANEL (I3) 1/4 to 1/2 full with
å
GLUE. Be sure to fi ll the second and fourth holes from the top
edge as shown.
Fasten the UPRIGHT (C3) to the BACK PANEL (I3). Tighten two
å
HIDDEN CAMS.
NOTE: Be sure the WOOD DOWELS in the UPRIGHT insert into
å
the holes in the BACK PANEL. Wipe away the excess glue.
54M
Maximum
210 degrees
Minimum
190 degrees
Page 10
C3
15F
Arrow
I3
These holes
must be here.
S u r
f a c
H I D
e w
D E N
i t h
C A
M S
15F
412093
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Roller end
www.sauder.com/services
Publicidad
