Publicidad
Step 5
First, fi ll the holes in a short edge of the BACK PANEL (I3) 1/4 to
å
1/2 full with GLUE (54M). Then, insert two WOOD DOWELS (15F)
into the holes. Wipe away the excess GLUE.
Next, fi ll the holes in the other short edge of the BACK PANEL (I3)
å
1/4 to 1/2 full with GLUE. Then, insert two WOOD DOWELS (15F)
into these holes. Wipe away the excess GLUE.
Now, fi ll the holes in the RIGHT END (E3) 1/4 to 1/2 full with GLUE.
å
Be sure to fi ll the second and fourth holes from the rounded edge
as shown.
Fasten the RIGHT END (E3) to the BACK PANEL (I3). Tighten two
å
HIDDEN CAMS.
NOTE: Be sure the WOOD DOWELS in the BACK PANEL insert
å
into the holes in the RIGHT END. Wipe away the excess glue.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
e w
f a c
S u r
I3
15F
Start
Arrow
M S
C A
D E N
H I D
i t h
54M
Maximum
210 degrees
Minimum
190 degrees
412093
Fill the holes 1/4 to 1/2 full with GLUE.
15F
Rounded edge
R i g
h t E
n d
E3
Tighten
Arrow
Roller end
Page 9
Publicidad
