Programming The User Code - SentrySafe Fire-Safe Manual Del Propietário

Programmable Electronic Lock
Programming information
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on
the back of the owner's manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be
changed or deleted.
Secondary code:
A 5 digit programmable code of your choosing that can be
changed or deleted. Can only be programmed after a user
code has been activated.
NOTE: The "C" key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).

Programming the user code

Only 1 user code can be programmed at a time.
To ADD a user code:
1 Press the "P" key.
Enter the 5 digit factory code.
2
The light will flash green and then you will have five seconds to enter your own
3
personal user code.
To DELETE a user code:
Press the "P" key.
1
Enter the 5 digit factory code.
2
3 Enter 0,0,0,0,0.
NOTE: The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
8
Programming the secondary code
Only 1 secondary code can be programmed at a time.
To ADD a secondary code:
Press the "P" key two times.
1
Enter the 5 digit user code.
2
The light will flash green and then you will have five seconds to enter your own
3
personal secondary code.
To DELETE a secondary code:
1 Press the "P" key two times.
2 Enter the 5 digit user code.
3 Enter 0,0,0,0,0.
NOTE: The electronic lock will NOT indicate that it has deleted the secondary code – please test
the code to make sure it has been deleted.
NOTE: Delay mode will occur if three consecutive invalid entries have been tried. This will cause
the system to shutdown for two minutes. Do NOT remove the batteries to restart the
system it will only increase the length of time for the system shutdown.
9