Operating Your Humidifier - Honeywell HEV312 Manual Del Usuario

OPERATING YOUR HUMIDIFIER

Output/Fan Speed Control
Step 1
Press power to start unit
in high speed.
Set Humidity
Step 1
Min: approximately 35%
Max: approximately 55%
Use the (
set desired humidity.
The unit will operate until the selected humidity is reached
or the unit is turned off. When desired humidity is reached,
the fan will shut off but LED will remain lit. The fan will
turn back on when the room humidity drops below the
set level.
NOTE: To go back to continuous run mode, turn your
unit off and on again.
4
Step 2
Push ( ) Up button or
( ) Down button to select
the output level.
) up or ( ) down button to
CHANGING YOUR FILTER
The filter should be changed every 1-3 months depending on your water quality. Keep in mind, depending
on your water quality, mineral deposits can still clog or discolor the filter, affecting it's life and that of the
humidifier.
It is recommended you change your filter in the bathroom or kitchen. Keep in mind your filter may be
damp depending on your last usage.
To change the filter:
Step 1 Step 2
Uses replacement filter Turn off and unplug
Filter A HAC-504AW. your humidifier.
Step 5 Step 6
Soak new filter in cool Insert new filter into
water. holding basket and
place filter holding
Do not squeeze out.
basket back in unit.
Step 3 Step 4
Remove the water tank Remove filter holding
and carefully set aside. basket and discard old
filter.
Step 7
Replace the water tank.
5