MTD Yard Machines MTD1400K Manual Del Operador página 4

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
PLEASE READ - SAVE THESE
INSTRUCTIONS
When using an electrical appliance, basic precautions
should always be followed to assure maximum safety and
optimum performance. Read this manual before assem-
bling and operating this appliance. Failure to comply with
instructions may result in electrical shock, burns, fire, or
personal injury.
WARNING
TO REDUCE THE RISK OF ELECTRIC
SHOCK, BURNS, FIRE OR PERSONAL
INJURY:
1. FOLLOW ALL SAFETY INSTRUCTIONS listed in
this manual before/during operation of this shredder.
2. TO REDUCE THE RISK OF ELECTRIC SHOCK this
shredder must be grounded. It is equipped with a
cord having an equipment-grounding conductor and
grounding plug to reduce the risk of electric shock.
Plug into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
DANGER: Improper connection of the equipment-
grounding conductor can result in a risk of electric
shock in the event of a malfunction. Contact a quali-
fied electrician if you are in doubt as to whether the
receptacle is properly grounded. Do not modify the
plug provided with the shredder.
INSPECT UNIT FOR DAMAGE to the housing, cord
3.
or plug. Keep all fasteners tight. Do not use if the
switch does not turn the unit off properly. Never use
unit if cord or plug has been damaged, the motor or
unit itself is not working as it should or has been
dropped, damaged, left outdoors or dropped in
water. Never operate with any air opening blocked.
Keep air openings free of debris that may reduce air
flow. Replace damaged parts that are chipped,
cracked or damaged in any way. This product is dou-
ble insulated - there are no serviceable parts inside.
4. GROUNDING INSTRUCTIONS This tool should be
grounded while in use to reduce the risk of electric
shock to the operator. The tool is equipped with a 3-
conductor cord and 3-prong grounding plug to fit the
proper grounding receptacle. If your unit is for use on
less than 150 volts, it has a plug as illustrated in
sketch A in Figure 1-1A. If it is for use on 150 to 250
volts, it has a plug as illustrated in sketch D, Fig.1-1A
An adapter, sketches B and C, is available for con-
necting plugs as illustrated in sketch A to 2-prong
receptacles. The green-colored rigid ear, lug, or the
like, must be connected to permanent ground, such
as a properly grounded outlet box. No adapter is
available for the plug illustrated in sketch D.
RULES FOR SAFE OPERATION
www.mymowerparts.com www.mymowerparts.com
GROUNDING
PIN
ADAPTER
GROUNDING
(C)
MEANS
METHOD OF SECURING EXTENSION CORD
CORD SET
APPLIANCE CORD
(A) TIE CORD AS SHOWN
EXTENSION CORD - Use only three-wire outdoor
5.
extension cords that have three-prong grounding
plugs and grounding receptacles that accept the
appliance's plug.
• When using the appliance, an extension cord of ade-
quate size must be used for safety and to prevent loss
of power and overheating.
• The extension cord must be specifically intended for
outdoor use and marked "SJ" or "SJT" and with the
suffix "WA". In Canada, the extension cord must be
marked "SFTW".
• Inspect extension power cord for loose or exposed
wires and damaged insulation. If damaged, replace
before using appliance.
DO NOT ABUSE CORD - Never carry appliance by
cord or pull cord to disconnect from outlet. Keep cord
clear of operator and obstacles at all times. Do not
expose cord to heated surfaces, oil or water. Do not
pull cord around sharp edges, corners or close door
on cord.
6. Avoid dangerous environment. Do not use appli-
ance in damp or wet locations.
7. Don't use in rain. Water entering a power tool will
increase the risk of electric shock.
8. Do not abuse cord. Never yank it to disconnect from
receptacle. Keep cord away from heat, oil, sharp
edges or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of elec-
tric shock.
3
METAL SCREW
COVER OF
GROUNDED
DUTLET BOX
(A)
(B)
GROUNDING
PIN
(D)
Fig. 1
(B) CONNECT PLUG AND
RECEPTACLE
Fig. 2
Table 1