Using The Appliance; Brushing Instructions - Philips sonicare HX9352/04 Manual De Instrucciones

12
English
- Flashing orange LED and three beeps: Only a few brushing
sessions left
- Flashing orange LED and two sets of five beeps: No brushing
sessions left (charge toothbrush)
Note: These indications are based off of using the device twice per
day in Clean Mode. Other modes or more frequent usage may
decrease the battery life.

Using the appliance

Brushing instructions

1 Wet the bristles (Fig. 8).
2 Apply a small amount of toothpaste on the bristles (Fig. 9).
3 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 10).
Note: Keep the center of the brush in contact with the teeth at all
times.
4 Press the power on/off and mode button to turn on your Philips
Sonicare (Fig. 11).
5 Gently keep the bristles placed on the teeth and in the gumline.
Brush your teeth with small back and forth motion so the bristles
reach between the teeth (Fig. 12).
Note: The bristles should slightly flare. Do not scrub.
6 To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth (Fig. 13).
7 Begin brushing in section 1 (outside top teeth) and brush for 30
seconds (45 seconds in Deep Clean mode) before moving to
section 2 (inside top teeth). Continue brushing in section 3 (outside
bottom teeth) and brush for 30 seconds (45 seconds in Deep
Clean mode) before moving to section 4 (inside bottom teeth (Fig.
14)).
Note: To make sure you brush evenly throughout the mouth,
divide your mouth into 4 sections using the Quadpacer feature
(see chapter 'Features').