pointed down, and stack. Do NOT operate in the stacking posi-
tion; operate only with unit sitting on its four rubber feet.
The black circular ring of the air intake is also useful as a cord
wrap.
MAINTENANCE
DANGER! Disconnect From Electrical Supply Prior To Ser-
vicing Or Cleaning: Do not attempt to service or clean the unit
while it is plugged into an electrical outlet or while the wheel is
turning as this may lead to risk of electrical shock or injury. It is
dangerous for an unqualified individual to attempt to disassem-
ble or repair the unit.
CLEAN AIR INTAKES: Clean the air inlet side screens of any
accumulated lint and or fabric. A build up will reduce the airflow
and may cause the motor to overheat and become a fire haz-
ard.
CORD INSPECTION: Inspect the electrical cord for damage.
Units with damaged cords must be removed and repaired be-
fore use. Failure to do so may lead to electrical shock, or a fire
hazard.
CLEAN EXTERIOR: Wipe with a damp cloth and a mild deter-
gent solution. Do not use a hose or a pressure washer. For
deep cleaning and a lasting, protective shine, use an automo-
tive interior cleaner and protectant.
EXTERIOR INSPECTION: Evaluate exterior components and
make sure that they are properly installed. Repair or replace
missing components as required. Listen to the unit for abnor-
mal sounds and repair as needed.
TROUBLESHOOTING
Solutions fall into two categories listed in the third column. Field Solutions (FS) are those procedures that can be handled by the technician
in the field. Others solutions should be handled by a repair technician and are listed as Authorized Service Technician (AST).
WARNING: All the service procedures below should be executed with the unit unplugged.
PROBLEM
Motor won't run.
1. Switch not turned on
2. No power at outlet
3. Switch is broken
4. Loose wiring
Motor runs but
1. Severe jolt has caused wheel to rub
wheel makes a
scraping noise.
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR
U.S.A. contact
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Phone US: 800 -932-3030
UK contact
DRI-EAZ PRODUCTS, LTD.
22 Plover Close, Interchange Park, Newport Pagnell, MK16 9PS
Tel: +44 (0)1908-611-211 Fax: +44 (0)1908-611-363 www.dri-eaz.co.uk
07-00323G F228-115V, F228-230V
CAUSE
against housing
Fax: 360-757-7950 www.dri-eaz.com
SPECIFICATIONS
Airwolf F228
Air volume
Static pressure
Amps
Size (L×W×H)
Weight
Motor
Wheel speed
Wheel size
Cord length
Safety
Specifications are subject to change without notice. Some
values may be approximate.
Caution
FS
1. Turn switch to appropriate speed
FS
2. Check outlet with receptacle tester
AST
3. Call factory for replacement switch
AST
4. Check wiring and tighten as needed
AST
1. Call your Dri-Eaz distributor for advice.
2
115 volt model
230 volt model
780 cfm
1,150 cmh
7.3 in. water
13 cm water
9.8 amps
4.9 amps
16 × 21 ×17 in.
40 × 52 × 44 cm
35 lbs.
16 kg
1 hp
0.75 kw
3,450 rpm
2,875 rpm
10.625 × 2 in.
27 × 5 cm
25 ft.
7.6 m
UL/cUL listed
CE
SOLUTION
Dri-Eaz Products, Inc.