Attaching The Canopy; Attaching The Safety Flag - Bell SMOOTH SAILER Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Disconnect the shoulder harness clips and the seat belt buckle. Place the children
side by side on the seat. Place shoulder strap A over the first child's right shoulder
and shoulder strap B over the first child's left shoulder. Place shoulder strap C over
the second child's right shoulder and shoulder strap D over the second child's
left shoulder.
Each child' s height will determine the position of his/her
respective shoulder straps. The shoulder strap height
may be adjusted by routing the straps above (for taller
children) or through (for smaller children) the horizontal
loops E. Figure
. For the first child, secure shoulder
5B
straps A and B to crotch strap 1. For the second child,
secure shoulder straps C and D to crotch strap 2. Adjust
the length of the shoulder straps and crotch straps so
that both children are held snugly in place. The crotch straps should be adjusted so
that the children do not slide too far forward. Make sure that the shoulder straps and
crotch straps are snug and secure for the safety of the children and the stability of the
trailer. Attach the seat belt across both children's laps.

ATTACHING THE CANOPY

Position the cover over the top of the trailer so the
reflectors are to the rear and the mesh screen window is
to the front. Fasten the cover at the bottom rear of the
trailer and work it forward until it is fully covering the
top and front of the trailer. Attach the lower rear clips to
the buckle to hold the rear of the cover in place. In hot
weather the front window can be rolled up and secured
with the loop straps to allow ventilation into the front of the trailer. Never use the
trailer without the front screen in place to protect your child's face from debris and
spray from the back wheel of the bicycle.

ATTACHING THE SAFETY FLAG

A two piece safety flag is included with the trailer.
It should always be used whenever you tow the trailer.
Insert the ends of each section into the orange
connectors to assemble, and insert into the canopy
sewn sleeve on the rear corner of the trailer.
Figure
.
7A
E
5B
6A
7A
9

Publicidad

Tabla de contenido
loading

Productos relacionados para Bell SMOOTH SAILER

Tabla de contenido