Publicidad
Idiomas disponibles
Idiomas disponibles
EN
TYPE OF WATER TO BE USED
Use only one of the two types of water listed below:
•
unscented demineralised water.
ASSEMBLY
•
Unpack the product.
•
Check that the product is intact and not damaged.
•
Insert the handle (1) in the steam mop body (16) until the handle release button clicks (7). [Fig
B1-A]
•
Remove the handle (1) by pressing the handle release button (7) and remove.
•
Clip the Brush (17) to the steam mop Body (16) until the steam brush release button clicks (17B). [Fig B1-B]
•
Remove the brush (17) by pressing the brush removal button (17B) and remove the brush.
•
Place the Microfibre Cloth for hard floors or rugs (19A or 19B) on the floor with the Velcro side
facing up and place the brush (17) on it and press lightly, making sure to cover the entire surface
of the brush. [Fig. B1-C]
•
The Cloth 19A is ideal for use on hard floors and parquet.
•
The Cloth 19B is ideal for use on rugs.
FILLING THE WATER RESERVOIR
•
Pull the lever for removing the water tank (14A) and remove it from the steam mop body. [Fig. C1]
•
Remove the reservoir cap (14B) rotating it anti-clockwise. Fill the reservoir with water up to the level
indicated with MAX. [Fig. C2]
•
Close the cap (14B) and reposition the water reservoir (14) in the relevant seat and turn it clockwise.
•
Slightly press the reservoir against the steam mop body until you hear the tank removal click (14A). [Fig. C3]
DO NOT leave water inside the reservoir between one use and another.
•
•
Empty the water from the reservoir (14) after each use.
WARNING: To fill the water reservoir (14) during use and clean you must ALWAYS turn off
the steam cleaner and repeat the filling operations.
FILLING THE DETERGENT RESERVOIR
•
Loosen the detergent reservoir cap by turning it anti-clockwise (10) on the back of the steam mop body.
•
Use the Doser for detergent (20) to fill the detergent tank (13) up to MAX level with common
detergent for floors/marble/parquet according to the surface to be cleaned. When dosing pure or
diluted detergent, follow instructions contained on the package of the detergent. [Fig. D1]
•
Once the tank has been filled (13), close it again by turning the detergent reservoir cap clockwise
(10) until it is completely closed.
WARNING: ALWAYS TURN OFF THE PRODUCT AND DISCONNECT THE PLUG
before loading the detergent reservoir (13)
DO NOT fill the detergent reservoir (13) with the product running.
•
•
Fully unwind the power cable (8). For this purpose, rotate the cable winder hooks (5 and 6). [Fig. E1]
•
Secure the cable (8) in the cable hook (4) on the rear part of the handle to prevent the cable from
12
PREPARATION
USE
Publicidad
