Bobrick CompacDryer B-710 Instrucciones De Instalación página 3

1. Fit cover over mounting base.
NOTE: Four sides of cover overlap the
mounting base and should be flush with
the sides, top and bottom of the mount-
ing base.
1. Turn electrical power supply on.
2. Position hands under air-outlet, within 4'' (100mm) of the bottom of the dryer.
3. Dryer should turn on. Warm air should blow from air-outlet.
4. Remove hands from under air-outlet and dryer should stop (within 2 seconds).
WarninG: 1. turn eLeCtriCaL suppLy off Before DoinG any maintenanCe or serViCe to Dryer.
2. Dryer must not Be operateD unLess CoVer is in pLaCe.
1. Exterior of cover should be cleaned with a damp cloth to remove dust and surface dirt. Do not use abrasive agents or solvents as they may
permanently damage surface of cover.
2. At least once every 12 months remove cover. Using a small brush or vacuum, clean out build up of dust and lint from air inlet/outlet grille, interior of
cover and around motor/fan housing.
NOTE: If dryer is installed where there is a lot of dust and dirt in the air, the interior of the dryer should be cleaned out more frequently.
important
installation Date: _____________________________________________________________________________________________________________
serial no(s).: _________________________________________________________________________________________________________________
installation address:___________________________________________________________________________________________________________
telephone no.: _______________________________________________________________________________________________________________
The Bobrick B-710 CompacDryer™ of the serial number(s) indicated herein, and all parts are warranted to the original owner of the installed unit for five years from
date of original purchase against defects in factory workmanship or material under normal use and service
This warranty is limited to repair or exchange of defective parts at the option of Bobrick.
this Warranty Does not CoVer aCCiDentaL DamaGe, improper hanDLinG or instaLLation, or repairs maDe By unauthoriZeD
per sons, anD speCifiCaLLy eXCLuDes CLaims for inDireCt, aCCi DentaL or ConsequentiaL DamaGes to property. the impLieD
Warranties of merChantaBiLity anD fitness for a partiCuLar purpose are LimiteD to the same Duration of the aBoVe War ranty.
Some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
normal service constitutes performing the following preventive maintenance procedure: Clean any lint, dust or grease from air-inlet and air-outlet grilles.
*
Labor costs for preventive maintenance shall be at owner's expense.
For repair or exchange of defective part, send the part together with installation date and serial number to BOBRICK.
Replace Cover
2. Replace and tighten three
Check Dryer Operation
Maintenance
Warranty
LimiteD Warranty
screws, one on each side and
one on the bottom to secure
cover to mounting base.
* .
saVe
Page 3