Adjust The Transmitter - Advent ADVW801 Manual De Instalación Y Operación

ADVW801_instructions_trilingual 1/6/04
POWER OPTION 2 AC ADAPTER
Turn the speaker Power ON-OFF/Volume Control
A
Knob (A) to the "OFF" position (all the way counter-
clockwise – it will "click" off).
Insert the power cord from the Speaker AC Adapter
B
(Q) into the Speaker Power Input Jack (C).
Plug the Speaker AC Adapter (Q) into any standard
C
wall outlet.
Speaker AC Adapter
15 V DC 800 mA (Q)
NOTE Be sure to use the AC Adapter rated 15 V DC
800 mA. The batteries will not recharge when the
speaker is powered with the AC adapter.
7 ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
4:05 PM Page 8
Power ON-OFF/
Volume Control
Knob (A)
Speaker Power
Input Jack (C)

Adjust the Transmitter

Adjust the transmitter as follows:
Turn ON your Audio Source
STEP 1
(i.e., Stereo Receiver, TV, etc.) so that you
can hear sound coming from the source.
STEP 2 Pivot the Antenna (O) to the upright,
vertical position.
Transmitter Audio Level
Indicator Light (J)
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
Set the Transmitter "Level"
STEP 3
Set the Frequency Control Wheel (N) to its
A
midpoint.
B Turn the Output Control Level Wheel (L) all the way
to the left (your left when looking at the transmitter
controls), as shown.
Check status of Transmitter Audio Level Indicator
C
Light (J). If it flickers intermittently (about half the
time), proceed to TUNE THE SPEAKERS.
If Audio Level Indicator Light (J) is on solid red or
D
flickering very rapidly, turn Output Control Level
Wheel slowly back to the right until light flickers
intermittently.
Frequency Control Wheel (N)
8