Publicidad
Idiomas disponibles
Idiomas disponibles
ADVW801_instructions_trilingual
1/6/04
About Variable-Level Outputs
A variable-level output, such as a headphone jack or
certain RCA-type outputs, provides an audio signal to
the transmitter that changes in relation to volume
level on the audio source. As the volume of the audio
source goes up and down, so too does the audio
signal strength sent to the transmitter. This can affect
the quality of sound you hear at the speaker, and may
require increasing or decreasing the volume level of
the audio source to achieve a suitably strong audio
signal for use with the ADVW801 system.
13
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
4:05 PM
Page 14
HINT On most bookshelf-type or compact stereo
systems, inserting a headphone plug into the
headphone jack results in automatic cutoff of the
regular, or hard-wired, speakers.
HINT Most TVs, regardless of age or price, have
variable outputs. If you are unsure which, if any,
of your outputs are fixed, refer to the TV instruction
manual. Some TVs have outputs that can switch
between variable and fixed. When given a choice,
fixed is always recommended.
Troubleshooting
The following troubleshooting guide takes you through some of the more common problems and corrections
associated with the installation and/or operation of a wireless system.
TROUBLE
CHECKS AND ADJUSTMENTS
No Sound
• Confirm that the Transmitter AC Adapter (P) is fully inserted into the wall outlet and the
power cord from the AC Adapter is firmly connected to the Transmitter Power Input Jack (K).
• Confirm that the speaker is turned ON.
• Confirm that the Speaker AC Adapter (Q) is fully inserted into the wall outlet and the
power cord from the AC Adapter is firmly connected to the Speaker Power Input Jack (C).
OR
• Check that the "D" cell batteries are fresh and inserted for correct polarity (+, –).
• Check that the audio source (stereo, TV, etc.) is turned on and providing sound as it
normally should.
• Check that the speaker volume is turned up.
• If you are using a Tape 2 Monitor output from your receiver/amp as the audio output,
check that you have pressed the Tape Monitor/Tape 2 button on the front of the receiver.
This will turn on the Tape 2 outputs, which may not be active.
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
14
Publicidad
Capítulos
