Installing The Handset Battery - GE 28321 Manual Del Usuario

Installation
8

Installing the Handset Battery

1. Locate batteries and battery door which are
packaged together inside a plastic bag and
are separate from the handsets.
2. Locate the battery compartment on the
back of the handsets.
3. Insert the batteries.
CAUTION: To reduce the risk of
fire or personal injury, use only
the Thomson Inc. approved
model GP AAAHC 1.2V 0mAh,
rechargeable Nickel-metal
Hydride AAA batteries, which are
compatible with this unit.
4. Close the battery compartment by pushing
the door up until it snaps into place.
5. Plug the AC power adaptor of the charge
cradle into an electrical outlet.
CAUTION: To reduce risk of
personal injury, fire, or damage
use only the
-292 power adaptor listed in the
user's guide. This power adaptor is
intended to be correctly orientated
in a vertical or floor mount
position.
Battery Performance
When batteries are fully
charged the handset
displays an icon of a full
battery. To keep your
batteries in the best
condition, leave the
handset off the charge
cradle for a few hours at
a time (after the initial 16
hour charge).
Battery Low Warning
The handset displays
a flashing icon of an
"empty" battery and
sounds a warning beep.
Recharge your handset
right away.
When charging the
battery, level bars are
animated.
Battery Charging Light
The blue charging light
on the handset charge
cradle stays on while the
handset is on the cradle,
even when the batteries
are fully charged.