Publicidad
Idiomas disponibles
Idiomas disponibles
English
□ THE NAILER MUST NOT OPERATE.
Pull the trigger
(6)
Without touching the trigger, depress the push
lever against the workpiece with pulling back the
feeder knob.
Next, pull the trigger.
□ THE NAILER MUST OPERATE.
Hold the trigger back and depress the push
lever against the workpiece again.
□ THE NAILER MUST NOT OPERATE.
Separate the fi nger from the trigger.
Next,
is operated again.
□ THE NAILER MUST OPERATE.
(7) Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE NAILER MUST NOT OPERATE.
(8) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
LOADING NAILS
● When loading nails into Nailer,
1) remove battery from the nailer;
2) do not pull trigger;
3) do not depress push lever; and
4) keep nailer pointed downward.
● Do not insert diff erent length sized nail
strips at same time. If do so, it could result in
damaging nail strips and jamming.
22
Pulling back
feeder knob
WARNING
2–Action Nail Feeding!
(1) Insert nail strip into the back of the magazine.
(2) Slide the nail strip forward in the magazine.
(3) Pull back the feeder knob while pushing the nail
feeder (A) to set the nail strip in place.
Nail feeder (A)
NOTE
● Quietly set the nail feeder (A) and feeder knob against
the nail.
If the nail feeder (A) and feeder knob are released
from backward the magazine and bumped against
the nail, the connecting paper of the nail can be
damaged.
● Use nail strip of more than 10 nails.
● Use an unbroken nail strip with nails of all the same
length.
The Nailer is now ready to operate.
Magazine
Feeder knob
Publicidad
