Weston 65-0501-W Manual De Instrucciones página 16

6. Remove the Plastic Lid Base,
2 Release Buttons and the 2
Release Springs from the Stainless
Steel Lid.
7. To install the new Lid Assembly,
turn the Plastic Lid Base upside
down with the Vacuum Chamber
Lid Seal positioned towards the
front of the Vacuum Sealer and the
Seal Bar Insulator facing you.
8. Place the 2 Release Buttons into
the slots (FIGURE 20). Insert the 2
Release Springs into the backs of
the Release Buttons.
9. With the Vacuum Chamber Lid
Seal positioned towards the front
of the Vacuum Sealer and the Seal
Bar Insulator facing you, carefully
position the Plastic Lid Base
Assembly back onto the Stainless
Steel Lid so that the 4 screw holes in the Plastic Lid Base line up with the 4 screw
posts on the Stainless Steel Lid.
10. Use one hand to hold the Plastic Lid Base and the other to insert and turn
the 4 Lid Screws. HINT: It may work better to tilt the Vacuum Sealer on its side
when installing the Lid Screws.
11.When all 4 Lid Screws are installed, the Plastic Lid Base should be flush to the
Stainless Steel Lid. If it is not, then the Lid Screws may be improperly installed
(i.e. crooked or not tight enough).
REPLACING THE SEAL BAR TAPE:
1. Press the ON/OFF Button on the
Control Panel to turn the Vacuum Sealer
"OFF".
2. Disconnect the Vacuum Sealer from
the power supply.
3. Make sure the Vacuum Sealer is
completely cool.
4. Pick at either end of the Seal Bar Tape
covering the Seal Bar Heating Element
until it lifts slightly (FIGURE 21). Grasp
the loose end and slowly pull
the Seal Bar Tape back over itself until
fully removed.
5. Remove the backing from a new strip of Seal Bar Tape. Be careful not to allow the
Seal Bar Tape to contact anything including itself while the adhesive side is exposed.
6. Hold one end of the Seal Bar Tape in each hand. Stick the left end of the Seal Bar
Tape to the flat area on the Base just left of the Seal Bar Heating Element. Apply the
Seal Bar Tape from left to right over the Seal Bar Heating Element. Make sure there
are no wrinkles or folds in the Seal Bar Tape once applied. The Seal Bar Tape should
fully cover the Seal Bar Heating Element.
16
Release Button
Release Spring
Seal Bar Insulator
Plastic Lid Base
Stainless Steel Lid
Screw
Posts
Seal Bar Tape
Seal Bar Heating
Element
FIGURE 20
FIGURE 21