Bluetooth Transmission; Maintenance; Battery; Low Battery Signal - VISIOMED bewell connect MyGluco BW-GL1 Manual De Instrucciones

9. BLUETOOTH TRANSMISSION

To transmit your measurement(s) onto on your smartphone or tablet, open the application
MyGluco and open the measurement screen. Turn on the Bluetooth function on your
smartphone or tablet and activate bluetooth mode on the glucose monitor.
There are two ways to activate the Bluetooth mode of the MyGluco and transmit the data to
your app. After the end of the measurement (the result is displayed on the screen) :
1. Keep the strip in the slot, and press the M button on the bottom left.
OR
2. Eject the strip by pushing up the Strip-Ejection button or remove the strip directly by hand.
After following this step (1 or 2), "OFF" is shown and the Bluetooth mode is activated :
The blue LED (top right) will begin to blink, once the connection between the meter and
device is established, the blue LED will stop blinking and stays on permanently. The data is
transmitted to the app.

10. MAINTENANCE

10.1 BATTERY

Your meter comes with two 1.5V AAA size alkaline batteries.

LOW BATTERY SIGNAL

The meter will display one of the messages below to alert you when the meter power is
getting low.
1. The " " symbol appears along with display messages: The meter is functional and the
result remains accurate, but it is time to change the battery.
2. The " " symbol appears with E-b, Error and low:
The power is not enough to do a test. Please change the battery immediately.

10.2 REPLACING THE BATTERY

To replace the batteries (m), make sure the meter is turned off.
1. Press the edge of the battery cover and lift it up to remove.
2. Remove the old batteries and replace with two 1.5V AAA size alkaline batteries.
3. Close the battery cover. If the batteries are inserted correctly, you will hear a "beep"
afterwards.
18 BewellConnect - BW-GL1 - User Manual - 022017v1