Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ONE-PIECE
D OORS
Please read and comply with the warnings and
reinforcement instructions on the previous page. They
apply to one-piece doors also.
• Center the door bracket on the top of the door, in line
with the header bracket as shown. Mark either the left
and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot holes
and fasten the bracket with 5/16"x1-1/2" lag screws
(not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation. (Refer to
the dotted line optional placement drawing.) Drill 3/16"
pilot holes and substitute 5/16"x1-1/2" lag screws (not
provided) to fasten the bracket to the door.
HARDWARE
SHOWN ACTUAL
SIZE
©
Nut 5/16"-18
LockWasher
5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Centerline
of Garage
Door
HorizoetaU and vertical
reinforcement
is needed for
doors
(fiberglass,
aluminum,
steel
door with
gUass panel, etc.).
(Not Provided)
For a door with no exposed
framing,
or for the optional installation,
use
5/16"x1-1/2"
lag screws (Not Provided)
to fasten door bracket.
®
Lock
,
Washer
5/16"
Top of Door
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
24

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido