Faucet Installation - Kohler K-13462 Manual De Usuario

1. Faucet Installation

Prepare the Site
NOTE: Before drilling the mounting hole, use the following
provisions for proper placement: (1) A 1-1/4" (32 mm) minimum to
1-1/2" (38 mm) maximum diameter mounting hole is required. (2) A
minimum distance of 1-3/4" (44 mm) is required between the back
of the spout and the wall to allow access to the screw. (3) A 1-1/8"
(29 mm) maximum distance is required between the sink bowl edge
and the base of the spout.
Determine the mounting hole location.
Drill a hole through the mounting surface according to the
surface manufacturer's instructions.
Install the Faucet
Install the stud to the underside of the faucet.
Slide the gasket over the flexible hoses and stud, then seat the
gasket in the groove on the underside of the spout.
Insert the spout with flexible hoses and stud through the
mounting hole.
From under the sink, slide the rubber washer and bracket onto
the stud.
Thread the nut onto the stud to secure the faucet to the mounting
surface.
Kohler Co.
Without Escutcheon
Supply Hoses
Gasket
Bracket
3
Spout
Stud
Rubber Washer
Nut
1124215-2-B