Flex FX2231 Manual Del Operador página 10

INSTALLING AND REMOVING THE SAW
To install the saw blade (Fig. 4):
a. Insert the blade (with its teeth facing the
cutting direction) into the slot of the blade
holder as far as the blade can go.
b. Pull down on the blade to verify that the blade
is securely locked in place.
NOTICE: When inserting the saw blade, the
back of the blade must rest in the groove of the
guide roller.
The tool can only accept most commonly
available T-shank blades.
To remove the saw blade (Fig. 5):
a. Rotate the blade release lever and remove
the saw blade.
b. Release the blade release lever.
Always wear protective
WARNING
saw blade from the tool. The saw blade is
sharp and may be hot after prolonged use.
INSTALLING AND REMOVING
ACCESSORIES
COVER PLATE
NOTICE: Use the cover plate when cutting
decorative veneers, plastics, etc. It protects
sensitive or delicate surfaces from damage. It is
mounted on the bottom of the tool base.
Installation:
Insert the front of the base into the front of the
cover plate and lower the jig saw (Fig. 6).
BLADE
gloves when removing the
Fig. 4
Fig. 5
Blade
Release
Lever
Fig. 6
1
-10-
Guide Roller
2