Flex FX2231 Manual Del Operador página 13

CHIP GUARD
Installation:
Insert the chip guard from the front of the saw,
snap the gearbox and the limit post is aligned
with the positioning groove of the gearbox.
(Fig. 13 & 14).
Disassembly:
Open the tabs and remove the chip guard
forward.
DUST COLLECTION PORT
The dust collection port on this jig saw is compatible
with Ø 32mm vacuum hoses or adapters.
Installation:
Align the dust collection port as shown and
insert the hook of the dust collection port into
the slot in the base, push the dust collection
port backward and tighten the clamp screw at
the front of the dust collection port (Fig. 15).
The dust collection port can be mounted on
either right or left side to accommodate cutting at
different angles of the base. Make sure that the
dust intake opening is facing the blade.
Disassembly:
Loosen the clamp screw and push the dust
collection port slightly forward to remove it
directly (Fig. 16).
Fig. 13
Limit
Posts
Positioning
Grooves
Fig. 14
Fig. 15
Clamp Screw
Fig. 16
-13-
Tabs
Hook