Operating And Maintenance Instructions - Scott Safety FH31 Manual Del Usuario

Note The PAPR must go through a
pre-use check in accordance with
the Operating
Instructions manual prior to use.
The breathing hose must be attached
to the blower
the Headtop - See Operating and
Maintenance Instructions.
While holding the headtop at either side
of the headband, offer your face into
the faceseal and ease the headband
over the back of the head
Tighten the headband by pulling the
elasticated headband
buckles, do this evenly
Ensure that there is a comfortable
tension and contact around the faceseal
with no gaps
Check for a good range of motion. The
faceseal should remain in contact with
the face
Note The headtop should feel firm
against the face
movement. Excessive tightening will
cause discomfort and may distort the
faceseal.
Do not use a headtop if you cannot
achieve a comfortable fit.
DOFFING
CAUTION do not remove the headtop
until you are in a safe and hazard free
zone
Once free of any hazard switch off the
blower
Pull the visor away from the face and
off the head
Place the headtop onto a clean surface
Remove the PAPR
with the Operating and Maintenance
instructions
Proceed with after use cleaning and
storage
FH31
and Maintenance
prior to donning
through the
with no undue
in accordance
AFTER USE CARE
Note If during use the equipment may
have become contaminated by hazardous
substances, the
be identified and properly removed or
the contaminated components must be
replaced before next use.
Disposal of
components must
in accordance with local regulatory
requirements.
Disconnect the breathing hose from
the blower
Inspect the headtop for worn, ageing
or damaged components
Carefully wash or wipe clean the
headtop with a warm water solution
containing a mild detergent
It is recommended that headtop visors
be wiped clean with Distel wipes, the
FH31 faceseal may be removed and
washed separately
If necessary, wash the outside of the
breathing hose carefully using warm
water solution
detergent
Ensure the breathing hose connections
are free from all dirt or debris that
could prevent an effective seal with the
blower
Once clean all components must be
left to dry naturally.
STORAGE
Device must be protected from damage
during transportation.
When not in use the equipment should
be stored in a clean, dry environment,
away from direct heat sources between
-10°C and +50°C, at a humidity of less
than 75% RH.
8
contamination must
the contaminated
be carried out
containing a mild