Publicidad
Idiomas disponibles
Idiomas disponibles
.
.
Make sure that the Main Light switch on the control
panel is pressed to OFF, and that transformer power
cord is disconnected from power source.
Use a screwdriver to loosen the screw holding the
lens in place.
While loosening the screw, hold the lens in
place so that it does not fall and break.
Lens
..........
®
®
,_
®
3.
Remove the lens.
4.
Pull out the light bulb and replace with a new bulb.
.
Bulb
(
(9
Reverse the instruction from "steps" 3-1for
installation.
1. To protect against electric shock, do not immerse
cord or plugs in water or other liquid;
2. Unplug from the outlet when not in use and before
cleaning. Allow to cool before putting on or taking
off parts;
3. Do not operate any outdoor cooking gas appliance
with a damaged cord, plug, or after the appliance
malfunctionsor has been damaged in any manner.
Contact the manufacturer for repair;
4. Do not let the cord hang over the edge of a table or
touch hot surfaces;
5. Do not use an outdoor cooking gas appliance for
purposesother than intended;
6. When connecting, first connect plug to the outdoor
cooking gas appliance then plug appliance into the
outlet;
7. Use only a Ground Fault Interrupter (GFI) protected
circuit with this outdoor cooking gas appliance;
8. Never remove the grounding plug or usewith an
adapter of 2 prongs;
9. Use only extension cords with a 3 prong grounding
plug, rated for the power of the equipment, and
approved for outdoor use with a W-A marking.
13
Publicidad
