Publicidad
Idiomas disponibles
Idiomas disponibles
STRUCTURE
1) 3-digit display;
2) Proximity key sensor;
3) Two colour LED (red/green);
4) Module connection cable connector (IN);
5) Module connection cable connector (OUT);
6) Configuration button;
7) Configuration dip switches used for:
1 indicating LED state (default
enabled)
ON
2 display state (default enabled)
3 RS485 BUS: 2Voice - Ipercom
1
2
3
mode / standalone mode.
Default: 2Voice/Ipercom
8) Terminal board;
9) Jumper for power from 2Voice / Ipercom
system (default) or local power supply.
DESCRIPTION OF TERMINALS
PS- Negative for door opener input relay
PS+ Positive for door opener input relay
-/~ Negative for local power
+/~ Positive for local power
N.O. Lock relay normally open contact
C
Lock relay common contact
N.C. Lock relay normally closed contact
10
CONFIGURATION FOR
OPERATION IN STANDALONE
MODE
Proceed as follows to configure the device:
— move jumper (9) to Local PS mode;
— set dip switch (7) number 3 to OFF state.
Proceed as follows:
1) Power on the device and check that the
following are displayed in sequence:
− the indication (display test);
− the caption (Initialization)
for a few seconds;
− the two-color led changes from red to green
and back to red again in sequence;
− the flashing dot, which indicates that the
device is operating correctly, (only if the
display is enabled by means of dip-switch
2).
2) Press the rear button briefly: the following will
appear on the display in sequence:
− the SW version of the device (e.g.);
− the indication.
3) Press the rear button again briefly to access
the MASTER key storage procedure; the
display will show:
4) Complete the push button panel installation:
all the next operations can be executed by
accessing from the front panel only.
5) From minimum 1 to maximum three MASTER
keys can be defined. The MASTER keys will
be used subsequently to program the device,
its parameters and user keys. Once they have
been numbered, the MASTER keys must be
carefully preserved possibly by the installation
technician or administrator of the building: they
DS1168-008A
Publicidad
