Urmet alpha 1168/45 Manual De Instalación página 12

1997 (identified by the presence of a dot).
Screen 2 can be used instead to delete keys from 1
to 999 (identified by no dot).
Move the MASTER key away from the unit and
back towards it to select the screen with the field to
which the key to be deleted belongs.
After selecting the screen, the display increases the
first bar by one unit at a time every second in a
cyclic way (from 0 to 9).
Remove the MASTER key when the digit you want
to set is displayed (the first digit of the number of
the lost key).
Repeat the above operations with the MASTER key
twice so as to set the other two digits. At this point,
the display shows the number of the lost key that is
to be deleted or replaced.
— If the number entered is not correct (i.e. it does
not correspond to the number of the key to
be deleted), do not perform other operations:
after 7 seconds, the device will return to normal
functioning WITHOUT deleting anything.
— If the number set is correct, approach (within
7 seconds) the MASTER key: the buzzer will
emit a beep and the key will be deleted from
the memory. The flashing key symbol will be
shown on the display for 7 seconds:
If you wish to store a new key and assign it the
SAME 'key number' as the one you just deleted,
approach the new key to the front panel when the
display flashes.
The buzzer sounds a tone to confirm that the key
has been replaced.
At this point, the device shows a symbol prompting
to delete/replace keys:
Repeat the same operations for all the keys to be
deleted or replaced.
To return to normal functioning, place a MASTER
key close to the front panel.
12
SETTING OF RELEASE OPEN TIME
When you access this menu, the display indicates
the currently set door release time (factory setting:
't00').
The door release time can be set between 0 and
99 seconds.
Move the MASTER key close to the panel and hold
it in position for at least 2 seconds. The LED display
shows:
The display increases the first bar by one unit at a
time every second in a cyclic way (from 0 to 9).
Remove the MASTER key when the digit to be set
is displayed.
Approach and remove the MASTER key so as to
also set the second digit. At this point, the display
will show:
where 'XY' is the new door release time set.
Approach the MASTER key again to make the
changes effective ("Sto" appears on the display to
indicate that it has been stored).
ADVANCED PROGRAMMING
FUNCTIONS
A number of particular functions, not generally
used, are described below.
DELETION OF AVAILABLE KEYS
To delete an available user key from the memory,
you can use a simpler procedure than that described
above for lost keys:
WARNING: the procedure must be performed with
one key at a time.
— using a MASTER key, access the deletion menu
with the following shown on the display:
— present the key to be deleted.
— if the key presented is effectively present in
the memory, the buzzer will emit three beeps
and the display will show the 'key number' for
approx. 7 seconds.
— when the key number is shown on the display,
present the MASTER key to confirm deletion.
'tXY'
DS1168-008A