Jasco 34932 Instruction Manual página 9

Programming Your Remote
6. With the remote pointed at the device,
press and release the VOL
The remote will re-send the first code of
the 10 codes from Step 4. The red light
will blink once and remain on.
Did the device turn off?
• If YES, you have found a code for the
device. Press and release the same
device button you pressed in Step 3.
This will store the code in the remote.
Go to Step 7.
• If NO, continue to press and release the
VOL
to test the other 9 codes from Step 4.
Be sure to wait approximately 3
seconds after each VOL
to allow the device time to respond to
the code. When the device turns off,
you have found a code for your device.
Press and release the same device
button pressed in Step 3. This will store
the code in the remote. Go to Step 7.
Notes:
• The VOL button can be used to go backwards
through each batch of 10 codes.
• The red indicator light will flash 2 times after testing
the first or last code in each batch of 10.
7. Use the remote to turn the device back on.
Test the buttons on the remote to see if
the device responds as you would expect.
If the buttons do not operate the device,
return to Step 2 and repeat this process
to search for a better code to operate the
device.
8. Repeat this process for each device you
wish to control.
button until the device turns off
9
button.
button press