Publicidad
5
1
R
x2
2
I
x2
3
K
x2
6
C
O
7
F
2
D
8
O
From the underside of
the deck set the black
rubber washers (R) on
top of the locking
washers (I) positioned
with the points up. The
tabs on the washers will
align with the groove in
the valve body. Tighten
the mounting nuts (K).
Use pliers to secure
nuts. Tighten the nuts
so that the points of the
metal washers are 1/16"
maximum from the
1/16"
underside of the deck.
Check that the
expansion nut is
threaded into the
bottom of the
adjustable shank.
Slide the
adjustable shank
(C) into the spout
body (O) and
position the shank
so the flat sides are
directly above the
grooves.
Slide the chrome
clip (D) onto the
flats of the shank
as shown and slide
down until tabs
lock into the
notches on the
valve body. Thread
the top mounting
nut (F) onto the
valve body over
the clip. The nut
secures the clip.
Place the
assembled shank
into the deck
opening.
9
1
S
2
J
3
L
10
C
11
*not included
no se incluye
non inclus
C
12
Q
2
3
B
A
x2
3
From the underside of
the deck set the black
rubber washer (S) on
top of the locking
washer (J) positioned
with the points up.
Tighten the mounting
nut (L). Check roll pin
location of mounting
nut (F). Use pliers to
tighten the nut so
that the points of the
metal washers are
1/16" maximum
1/16"
from the underside
of the deck.
Slide the spout
shank to the
lowest position.
Shank height can
be adjusted at
spout installation.
To secure the
shank use a 3/8"
drive ratchet with
a 6" extension
(not included or
150313 tool).
Tighten the
expansion nut
inside of the
shank (C) by
turning clockwise
before pressure
testing.
Thread in the test
plug (B) and
pressure test for
leaks. Do not reuse
test plug (B) NOTE: If
pressure testing
exceeds 125 psi,
replace test plug (B)
with brass test plug
from Service Kit
#100538. Slide on
valve covers (A) and
shank cover (Q).
Publicidad
