Makita GSL02 Manual De Instrucciones página 23

NOTE: The maximum width of workpiece which can
be secured by the horizontal vise is 68 mm (2-11/16").
Sub base
WARNING:
Always support a long workpiece
so it is level with the top surface of the turn base
for an accurate cut and to prevent dangerous loss
of tool control. Proper workpiece support will help
avoid blade pinch and possible kickback which may
result in serious personal injury.
WARNING:
Before the cutting operation,
always be sure that the sub bases are secured by
the screws.
To hold long workpieces horizontally, sub bases are
provided on both sides of the tool. Loosen the screws
and extend the sub bases to the appropriate length for
holding the workpiece. Then tighten the screws.
1
► 1. Sub base 2. Screw
When cutting, place the workpiece flat against the guide
fences.
► 1. Guide fence 2. Sub base
OPERATION
This tool is intended to cut wood products. With appro-
priate Makita genuine saw blades, following materials
can also be sawed :
— Aluminum products
Refer to our website or contact your local Makita dealer
for the correct circular saw blades to be used for the
material to be cut.
WARNING:
is not contacting the workpiece, etc. before the
switch is turned on. Turning the tool on with the
circular saw blade in contact with the workpiece may
result in kickback and serious personal injury.
WARNING:
raise the circular saw blade until it has come to a
complete stop. The raising of a coasting blade may
result in serious personal injury and damage to the
workpiece.
WARNING:
such as turning grip, levers, stopper pin on the
tool while the circular saw blade is rotating.
Adjustment while the circular saw blade is rotating
may result in serious personal injury.
NOTICE:
per pin and release the handle from the lowered
position.
NOTICE:
handle when cutting. Too much force may result in
2
overload of the motor and/or decreased cutting effi-
ciency. Press down handle with only as much force as
necessary for smooth cutting and without significant
decrease in blade speed.
NOTICE:
form the cut. If the handle is pressed down with force
or if lateral force is applied, the circular saw blade
may vibrate and leave a mark (saw mark) in the work-
piece and the precision of the cut may be impaired.
NOTICE:
riage toward the guide fences without stopping. If
the carriage movement stops during the cut, a mark
1
may be left in the workpiece and the precision of the
cut may be impaired.
Press cutting
WARNING:
2
of the carriage when performing a press cutting.
Cutting without lock may cause possible kickback
which may result in serious personal injury.
Workpieces up to 70 mm (2-3/4") high and 92 mm
(3-5/8") wide can be cut in the following manner.
1. Push the carriage toward the guide fences until it
stops and lock it with the stopper pin.
2. Secure the workpiece with the proper type of vise.
3. Switch on the tool without the circular saw blade
making any contact and wait until the circular saw blade
attains full speed before lowering.
23 ENGLISH
Make sure the circular saw blade
After a cutting operation, do not
Do not perform any adjustment
Before use, be sure to unlock the stop-
Do not apply excessive pressure on the
Gently press down the handle to per-
During a slide cut, gently push the car-
Always lock the sliding movement