Moonah Installation Instructions
WOBBLE:
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE
MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING IT
WILL CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW CENTIMETRES IS QUITE
ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH FIX THE MOUNTING
BRACKET AND DOWN ROD ARE SECURE.
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour "breaking-in" period, most noises associated with
a new fan disappear during this time. Please note that this is not a product fault and as such is not coverd
under warranty – All electric motors are audible to some extent.
CARE AND CLEANING:
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn power off when you do so.
Do not use water when cleaning your ceiling fan. It could damage the motor or blades and create the
possibility of an electrical shock.
The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn off the power at the mains switch before attempting to clean your fan.
Ceiling Fan model
Moonah fan without light
Moonah fan with light
IN AUSTRALIA / NEW ZEALAND – Please refer to the separated WARRANTY STATEMENT.
IN EUROPE – If you are a European customer please contact the retail outlet where the fan was
purchased for warranty service.
12 | P a g e
AFTER INSTALLATION
TECHNICAL INFORMATION
Rated Voltage
Rated Power (motor)
220 - 240 VAC
220 - 240 VAC
WARRANTY INFORMATION
Rated Power (lamp)
75W
n/a
75W
18W, LED, 3000K