LUCCI AIRFUSION CLIMATE II LD52BN Manual De Instrucciones De Instalación página 12

Note: For your safety, new receiver must be installed by a licensed electrician.
Note: While repairing the DC ceiling fan remote and receiver is in process, the fan operates at highest speed
with REVERSE mode automatically for 90 seconds, and then operates with FORWARD mode for 90 seconds.
During the paring process, do not press any key on the remote.
BALANCING / WOBBLYING TROUBLE SHOOTING
Please note that all ceiling fans are not the same, even in the same model—some may move more or less than others.
Movement of a couple of centimetres is quite acceptable and does not suggest the fan will fall down.
Even though all blades are weighted and grouped by weight, it is impossible to eliminate wobble altogether. This should
not be considered a fault. Ceiling fans tend to move during operation due to the fact that they are not generally rigidly
mounted
You may do the following action to reduce the wobbling
1) Check all the blade mounting screws are tightened and securely.
2) Wobbling problems may result from inconsistent blade level. To check blade level, measure the distance from each
blade tip to the ceiling.
Note: If measurements are inconsistent:
- check blade mount screws are not over tightened or loose, which can cause the blade tip to not all sit level;
- An out of shape blade can cause wobbling, check by removing the blade and lay in on a flat surface. A good flat
blade will lay flat on the surface.
3) Blade tracking may be checked simply by use of a household ruler as shown in below Figure. Place the ruler
vertically against the ceiling and even with
the outside leading edge of a blade. Note
the distance of the edge of a blade same as
others. Turn the blade slowly by hand to
check the remaining blades. If a blade is
not in alignment, the blade is either out of
shape / warped or the blade screws are not
evenly tighten or either loose.
BALANCING KIT
1.
A Balancing Kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction on how to
use the Balancing Kit, that is included
2.
The balancing kit can be used to assist re-balancing if the ceiling fan becomes un-balanced overtime. Do not discard
the balancing kit. Retain for possible future use.
FAN CARE AND WARRANTY INFORMATION
CARE & CLEANING
 Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid
scratching the paint/plated finish. Please make sure the fan is not operating when cleaning.
 Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility
of an electrical shock.
Fig. 12
12