Temperature Limitation; Connection Test - Alpha IP RTA 61001-N1 Guia De Inicio Rapido

Operation
value balance of -2 K to 2 K in 0.5 K increments.
1. Remove setting wheel (E). There is a scale for the balance on the inside of the
setting wheel (E) (see fig. 7 page 5).
2. Insert the set point correction limiter (F) to the desired place in the setting wheel (E).

6.2 Temperature limitation

The temperature range for the target temperature to be set as a maximum and
a minimum can be limited via the set value elements on the inside of the setting
wheel (E) (see fig. 8 page 5).
1. Remove setting wheel (E). Read the scale for the limitation on the inside of the
setting wheel (E).
2. Insert the target value elements (G) into the setting wheel (E) indicating the de-
sired range.

6.2.1 Connection test

During this verification the room control unit Analog sends a switching command
to the base station. Depending on the switching status the assigned heating zone
has, it will be switched on or off after receiving the command.
36