Klein Tools CL360 Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
To ensure safe operation and service of the meter, follow these
instructions. Failure to observe these warnings can result in
severe injury or death.
• Before each use verify meter operation by measuring a known
voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT III or CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away from the
metal probe contacts when making measurements.
• Use caution when working with voltages above 25V AC RMS or 60V
DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock, replace
batteries when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• To avoid risk of electric shock, disconnect leads from any voltage
source before removing battery door.
• To avoid risk of electric shock, do not operate meter while battery
door is removed.
Alternating Current (AC)
Ω
Resistance (ohms)
Warning or Caution
Double Insulated Class II
V
Voltage
Alternating Current (AC)
Voltage (Volts)
Continuity
Non-Contact Voltage Testing
Resistance (Ohms)
Auto-Ranging
kilo (value x 10
4
WARNINGS
SYMBOLS ON METER
SYMBOLS ON LCD
)
3
Direct Current (DC)
Audible Continuity
Risk of electrical shock
Ground
A
Amperage
Direct Current (DC)
Amperage (Amperes)
Data Hold
High Voltage
Low Battery
Auto-Power Off
Mega (value x 10
Negative Reading
)
6

Publicidad

Tabla de contenido
loading

Tabla de contenido