Replacement Parts; Assembly Procedure For Seals; Maintaining The Pneumatic Tool - Bostitch BTFP12569 Manual De Operación Y De Mantenimiento

IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANUAL
OBSERVE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval
from BOSTITCH.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Before using the tool, verify that the actuator is in the non-actuated position. With the tool
disconnected from the air supply, depress the actuator and confirm it returns to the non-actuated
position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your
nearest BOSTITCH representative if your tool continues to experience functional problems.
When working on air tools, note the warnings in this manual and use extra care evaluating
problem tools.
Pusher spring (constant force spring). Caution must be used when working with the
spring assembly. The spring is wrapped around, but not attached to, a roller. If the
spring is extended beyond its length, the end will come off the roller and the spring
will roll up with a snap, with a chance of pinching your hand. Also the edges of the
spring are very thin and could cut. Care must also be taken to insure no permanent
kinks are put in the spring as this will reduce the springs force.

REPLACEMENT PARTS:

BOSTITCH replacement parts are recommended. Do not use modified parts or parts which will not
give equivalent performance to the original equipment.

ASSEMBLY PROCEDURE FOR SEALS:

When repairing a tool, make sure the internal parts are clean and lubricated. Use Parker "O"-LUBE
or equivalent on all "O"-rings. Coat each "O"-ring with "O"-LUBE before assembling. Use a small
amount of oil on all moving surfaces and pivots. After reassembly add a few drops of BOSTITCH Air
Tool Lubricant through the air line fitting before testing.
AIR SUPPLY-PRESSURE AND VOLUME:
Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate
because of undersize fittings and hoses, or from the effects of dirt and water in the system. Restricted
air flow will prevent the tool from receiving an adequate volume of air, even though the pressure
reading is high. The results will be slow operation, misfeeds or reduced driving power. Before
evaluating tool problems for these symptoms, trace the air supply from the tool to the supply source
for restrictive connectors, swivel fittings, low points containing water and anything else that would
prevent full volume flow of air to the tool.
BTFP12569_9R209353 MAN_Multi.indd 7
MAINTAINING THE BTFP12569 TOOL
-7-
1/27/15 9:29 AM