Combining Two Dwa-01D Adapters - Sony DWA-01D Manual De Instrucciones

connectors to the AUDIO IN connectors of
the camcorder.
For the camcorder that accepts
digital audio
Set the ANALOG AES/EBU selector to
AES/EBU, and connect the OUTPUT2
connector to the AUDIO IN connector of
the camcorder using an audio cable
supplied with the DWA-01D. Be sure to set
the camcorder so that the AUDIO IN
connector accepts AES/EBU digital audio
signal.
On connecting word clock
sync signal and digital audio
signal
The DWR-S01D attached to the DWA-01D
and the device connected to the DWA-01D
through the digital audio interface can be
operated properly, under either of the
following conditions:
• The device that is connected to the
OUTPUT2 connector of the DWA-01D
is equipped with a sampling rate
converter.
• The DWR-S01D is synchronized with
the device that is connected to the DWA-
01D using the master word clock signal
input to the WORD SYNC connector of
the DWA-01D.
There are two types of systems for
synchronization using the master word
clock signal.
System example 1
The master word clock signal is split using
the T-shaped BNC splitter.
One of the devices including the DWR-
S01D must be terminated.
For details on how to terminate the word sync signal
on the DWR-S01D, refer to the Operating
Instructions supplied with the DWR-S01D.
a) a)
c)
a) 75-ohm termination setting: OFF
b) 75-ohm termination setting: ON
c) Master word clock signal
System example 2
The master word clock signal is supplied to
each device using the distributor. All the
devices must be terminated.
a) a)
b)
a) 75-ohm termination setting: ON
b) Master word clock signal
c) Word sync signal distributor
Combining two DWA-01D
adapters
Two DWA-01D adapters, each of which a
DWR-S01D is attached, can be combined
to make a four-channel wireless receiver.
1
Remove four screws from the V-
shaped mount bracket and detach the
bracket.
Keep the removed screws in the screw
holes on the bracket for storage.
Attachment and connections
a) b)
a) a)
c)
23