Installation - FAAC TM2 X W Manual Del Usuario

INSTALLATION

The sensor is housed in a plastic container made
up of two parts: a base attached to the terminal
bar and a snap-on shell.
The shell contains the sensor processor board,
the battery compartment and the programming
commands.
The base is attached to the terminal bar with M4 screws
(not included) or the double-sided adhesive already
found on the back. Inside of the base, there is an arrow
that enables the identification of the proper direction for assembly
of the sensor: put arrow upwards.
Best Position: internal side of the bar.
The sensor must be assembled parallel with the end bar.
Attention: do not insert the sensor inside of the end bar profile but install the sensor
on the internal side of the end bar, at the end closest to the motor or to the control
unit or in any event within 10 metres.
NO
Make sure that there is enough space and TM2 X W does not get damaged by closing
the awning!
TM2 X W
BATTERY COMPARTMENT
20
BASE
SET BUTTON
LED
SELECTOR
YES
A4518_6H02_Rev.A
SHELL
YES