Disable The Sensor; Maintenance; Changing Batteries - FAAC TM2 X W Manual Del Usuario

DISABLE THE SENSOR

To deactivate the TM2 X W proceed as following:
- Open the awning completely and wait for at least ten seconds after the terminal
bar has stopped moving before beginning to unsnap the sensor.
- Press both snap hooks sideways at the same time while pulling the shell downward,
until it comes away from its base. Use no tools for this procedure (screwdrivers, or
similar items).
- As soon as the shell has been unsnapped, rotate the selector to the 0 position:
the LED will then flash three times slowly (0.5 seconds ON - 0.5 seconds OFF), to
confirm the fact that the sensor has been deactivated and cannot trip an alarm.
SELECTOR
To enable the sensor once again, follow the activation procedure as indicated.

MAINTENANCE

To make any changes to the alarm trip thresholds, to change the batteries or to
perform any other programming operation, the shell must be unsnapped from its
base. To perform this procedure, without the sensor tripping an alarm that will close
the awning, creating a potentially hazardous situation for persons in the vicinity,
it's necessary to disable the TM2 X W (check paragraph DISABLE THE SENSOR).

CHANGING BATTERIES

When the batteries are almost drained, the LED will flash regularly every two se-
conds. Change the batteries.
When changing the batteries, it's possible to use the Automatic Deactivation of the
sensor:
- Unsnap the shell from the base
- Rotate the shell and keep it vertical for
around 3 seconds
- The sensor will automatically deactivate.
When the new batteries are placed, the sensor will reactivate automatically: just
snap again the shell on the base.
Under normal use conditions, the batteries should last over two years. In any event,
it is suggested that the batteries be changed at the beginning of each new season.
TM2 X W 25
3 sec
A4518_6H02_Rev.A