Warnings And Cautions; Prepare For Installation; Tools Needed - Schlage Control FE410F Instrucciones De Instalación

Warnings and Cautions

Warnings indicate potentially hazardous conditions, which if not
avoided or corrected, may cause death or serious injury.
Cautions indicate potentially hazardous conditions, which if
not avoided or corrected, may cause minor or moderate injury.
Cautions may also warn against unsafe practices.
Caution: Cautions indicate a condition that may cause equipment
or property damage only.

Prepare for Installation

Tools Needed

• Phillips screwdriver
• Tape measure
Determine the Handing
Determine the handing of your door. Directions for changing lock
handing are provided throughout the instructions.
Outside of door
Left hand
If the handing is incorrect, locking and unlocking could be
reversed, resulting in an unsecured residence.
Important Notes
Install and test lock with door open to avoid being locked in or out!
Caution: Use provided bolt!
DO NOT use a power drill for installation!
2
WARNING
CAUTION
Optional Tools
• Flathead screwdriver
• Torx driver
TM
Right hand
CAUTION
WARNING
Check door dimensions.
See consumer.schlage.com/Service-Support for door preparation
instructions if dimensions are different.
Crossbore
Diameter
2Z\," (53 mm)
The firecup cannot be installed on a 1C\," (35 mm) thick door,
L
and the lock will not retain the UL rating.
Backset
2C\," OR 2C\v"
(60 mm OR 70 mm)
1" (25 mm) Hole
5Z\x" OR 4"
(140 mm OR 102 mm)
Door Thickness
1C\," to 1C\v"
(35 mm to 44 mm)