Publicidad
Idiomas disponibles
Idiomas disponibles
Ground cylinder connection
WARNING
Do not use a wrench to tighten the connection. Using
a wrench could damage the regulator coupling and
could cause a leak.
To light
1. Open the lid.
2. Make sure the control knob is turned OFF. (Push
control knob in and turn clockwise to ensure
that it is in the OFF position.)
3. Push burner control knob down and turn to HI
/ START (
) (Fig. 18)
4. Push the red ignition button several times, so it
clicks each time (Fig.19)
5. Check that the burner is lit by looking down
through the cooking grid. You should see a
flame.
6. Turn OFF the gas supply at the gas container
after use.
DANGER
Do not lean over the open grill. Keep your face and
body at least one foot away from the grill when
lighting the grill.
Fig. 18
DANGER
If the burner does not light, turn the burner control
knob to OFF and wait 5 minutes to let the gas clear
before you try again.
Fig. 17
Fig. 19
DANGER
Failure to open the lid while igniting the grill's
burner, or not waiting 5 minutes to allow the gas
to clear if the grill does not light, may result in an
explosive flame-up which can cause serious bodily
injury or death.
6. The burner may be match lighted if there is no
ignition.
a. First, remove the match extension stick from
the storage compartment (Fig.20)
b. Push the match into the clip of extension
stick (Fig.21)
c. Hold extension stick close to Burner and
turn control knob slowly (Fig.22)
d. Adjust flame to desired heat level. (Fig.23)
To extinguish
Push in and turn burner control knob clockwise to
the OFF position (Fig.23)
Leak check
Check:
1.1
Gas
canister
SUPER-EGP (Fig.25).
1.2 Extension hose connector (for ground type gas
cylinder) to Grill built-in regulator connection.
This is optional to Grill (Fig.26).
1.3 Check that seals (between the appliance and
the gas containers) are in place and in good
condition before connecting to the gas
container.
ENGLISH
Fig. 20
Fig. 22
to
adaptaor
Fig. 21
Fig. 23
(SEH019600)
15
Publicidad
