Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Printer
In order to enable the printing function press key. Measured values
will be printed each 15 seconds, and the Dielectric Absorption Index and
Polarization Index will be printed after 1 minute and 10 minutes
respectively. Printing may be started or stopped at any time during the
test. However, it is convenient to turn the printer on before starting the
test in order to print it complete, including the heading.
ATTENTION: Don't pull the paper. The printer can be easily damaged.
This printer uses 56 mm-wide thermal paper, which comes in a 30 mm-
diameter reel.
Pull the lever located on the lid.
Insert the paper reel as shown in the figure.
Keep the tip of the paper out of the printer and close the lid.
12. Cleaning
The panel, terminals and connectors of the equipment must stay dry and
clean. Cleaning should be made using a wet cloth in water and a soft
detergent or isopropyl alcohol (be sure that the products to be used for
cleaning does not affect plastic goods).
33
Publicidad
Capítulos
Tabla de contenido
