Automatic Operation - comatec RC08A Manual

NOTE
For several minutes after the start of heating operation, the indoor fan will not run until
the indoor heat exchanger coil has warmed up sufficiently. This is because the COLD
DRAFT PREVENTION SYSTEM is operating.
DEFROSTING OF HEAT EXCHANGE / OUTDOOR UNIT "STANDBY"
When the outdoor temperature is low, frost or ice may appear on the heat
exchanger coil,reducing the
microcomputer defrosting system operates. At the same time, the fan in the
indoor unit stops until defrosting is completed. Heating operation restarts after
several minutes. (This interval will vary slightly depending on the room and
outdoor temperature).
HEATING PERFORMANCE
A heat pump air conditioner heats a room by taking heat from outside air. The
heating efficiency will reduce when the outdoor temperature is very low.

AUTOMATIC OPERATION

1. Set the MODE selector to AUTO
2. Press the ON/OFF (
3. Press the + or -. buttons to set the desired temperature (The temperature range is
between 16℃ and 30℃(61-86F).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
When this setting is selected, the air conditioner calculates the difference between the
thermostat setting and the room temperature and automatically switches to the COOL,
DRY or HEAT mode as appropriate.
4. Switch the FAN SPEED selector button to the setting you want.
heating performance.
.
) button and switch the air conditioner ON.
7
OPERATIION
When this happens, a