Kohler K-T376 Guia De Instalacion página 6

Front Plate
Assembly
Escutcheon
3. Install the Trim
NOTE: If you are installing the K-T10424 trim, proceed to the
"Install the Trim - K-T10424" section of this guide.
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve with the correct length
screw, as selected in the "Install the Valve Stem Adapter" section
of this guide.
Align the holes on the front plate assembly and the valve.
NOTE: Be sure to select the correct length screw for your
application.
Attach the two screws through the front plate assembly and into
the valve. Do not overtighten.
Visually inspect the front plate assembly to ensure that the foam
seal is completely covering the wall opening. If not, stop the
installation and repair the wall opening.
Place the escutcheon against the wall. The drain hole in the
escutcheon should face downward in the 6 o'clock position.
Turn the handle assembly to the vertical 12 o'clock position.
Thread the handle assembly onto the hub of the front plate
assembly to secure the escutcheon in place.
NOTE: If the handle does not engage the valve or the escutcheon
does not tighten to the wall, replace the valve stem adapter with an
adapter of appropriate length.
1041514-2-K
Transfer Valve
Valve Stem Adapter
Screw
Screws
Handle Assembly
6 Kohler Co.