Kohler Purist K-14435 Guia De Instalacion página 5

4. Anchor Installation
NOTE: You may need to disassemble some of the accessories. Some
accessories will be packed with the wall plate installed in the post.
Loosen the setscrew and remove the wall plate if needed.
Press and hold the legs of a wall anchor (provided) together and
insert the wall anchor legs into the hole. Insert all wall anchors into
the pre-drilled mounting holes.
With a hammer, carefully tap each wall anchor until they are flush
with the finished surface.
If the wall anchor was inserted into a space between the studs, it
will be necessary to spread the wall anchor legs.
To spread the anchor legs, insert the supplied red key into the wall
anchor hole.
Repeat for all wall anchors inserted between studs.
Ensure that the wall anchors are flush with the finished surface.
5. Wall Plate Installation
Orient the wall plate with the large slotted mounting hole down and
the smaller hole over the higher anchor.
Secure the wall plate with the supplied panhead screws.
Repeat at each wall plate location.
Kohler Co. 5 1020118-2-B