Leister GEOSTAR G5 Instrucciones De Servicio página 34

Setting the threshold value for recording:
• Rotate the "e-Drive"
Rotate the "e-Drive"
Switching off alarm value monitoring (optionally, as required):
• See Switching on data recording for the setting procedure.
Important: When the alarm is switched off, then exceeded alarm values will also not be recorded.
Switching off the acoustic alarm (optionally, as required):
• See Switching on data recording for the setting procedure.
Setting the minimum temperature alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the maximum temperature alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the Parameters for Welding Data Recording
Setting the minimum force alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the maximum force alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the speed tolerance alarm:
• See Setting the threshold value for recording for the setting procedure.
Setting the distance interval:
• See Setting the threshold value for recording for the setting procedure.
Switching off GPS (optionally, as required):
• See Switching on data recording for the setting procedure.
• In the function display (33), rotate the "e-Drive"
Running Welding Data Recording
34
to select "Init. Value Record." and press "e-Drive"
to set the value and press "e-Drive"
• Set the parameters for welding data recording (see Chapters
• Set the setpoints for temperature and speed
(see Chapter "Speed and Temperature Setting Before Welding" in
the device operating instructions).
• Switch on the heating and drive.
In the status line (35), the file number is displayed alternately in
the network voltage display and the
• Activate clamping arm.
Recording begins as soon as the force exceeds the set threshold
value.
In the status line (35), the file number is displayed alternately
in the network voltage display and the
briefly.
to select the symbol "Return to working display"
"Preparing for Welding Data Recording" and "Setting the Pa-
rameters for Welding Data Recording").
briefly.
symbol flashes.
symbol is shown.
.