Geolocation
Warnings and error messages
• If there is a warning pending, the user can continue to work. You can access more detailed information about the
warning in question via the function display (33) by selecting "Show Warnings" in the Settings menu.
Important: If one of the listed warnings occurs, data recording cannot be used.
• If a warning occurs while welding, this can be displayed with the "Up" key.
• If an error occurs, the heating is switched off and the drive is no longer released.
Message
Display
type
Warning
38
GPS location status display:
• The symbol
reception is sufficient and location information is available. The
symbol flashes if, for example, reception is insufficient and valid
position information is required.
Note: The WLAN connection status is also displayed in the same
position in the status line. When a WLAN connection
to the myLeister app is present, the
even when GPS location information is available.
Requesting the current geolocation:
• In the function display (33), rotate the "e-Drive"
the Settings menu
• Press "e-Drive"
• Select "Welding Data Record." in the "Setup" menu by rotating
the "e-Drive"
• Rotate the "e-Drive"
"e-Drive"
Error code/warning
message
Unknown HMI Version
Date/Time halted
Invalid Date/Time
Memory Full
is displayed in the status line (35) when GPS
.
briefly.
and pressing it briefly.
to select "GPS Position" and press
briefly.
Error description
An error occurred when initializing the opera-
ting unit.
1
An error occurred when initializing the date and
time function.
The current date and time information is invalid.
Memory for data recording is full.
symbol flashes in the status line (35)
The
during data recording.
symbol is displayed,
to select