TFA 30.3047 Instrucciones Para El Manejo página 12

TFA_No_30.3047_Anl_ 05.06.2012
SELECT - Wireless thermometer
5. Elements
5.1 Basic unit
A: Display (Fig. 1):
A 1: Outdoor temperature with trend pointer
A 2: Indoor temperature
A 3: Time, seconds, date and time signal - symbol
B: Buttons:
Buttons front (Fig. 1):
B 1: MODE button
B 2: SNOOZE/LIGHT button
B 3: ALARM button
Buttons backside (Fig. 2):
B 4: SEARCH button
B 5: -/°C/°F button
B 6: ALERT button
B 7: +/12/24 button
B 8: MAX/MIN button
B 9: RESET button
C: Housing (Fig. 2):
C 1: Wall mount hole
C 2: Battery compartment
C 3: Stand (fold out)
5.2 Outdoor transmitter (Fig. 3):
D 1: Transmission signal lamp
Button inside the battery compartment
D 2: RESET button
22
10:32 Uhr Seite 12
SELECT - Wireless thermometer
Housing (Fig. 2):
D 3: Wall mount hole
D 4: Battery compartment
D 5: Stand (fold out)
6. Getting started
Insert batteries:
• Place both instruments on a desk with a distance of approximately
1.5 meter. Check that no other electronic devices are close.
• Open the battery compartment of the transmitter by pushing the bat-
tery compartment cover downwards (see marking) and lift the cover.
• Insert two new batteries 1,5 V AAA, ensure battery polarity is correct.
• Close the battery compartment again.
• Open the battery compartment of the basic unit and insert two new
batteries 1,5 V AAA, ensure battery polarity is correct.
• A brief beep tone will sound and all LCD segments will light up for a
short moment.
• Close the battery compartment again.
• The indoor temperature appears on the display.
Reception of outdoor temperature
• After the batteries are inserted the outdoor temperature will auto-
matically be transmitted to the basic unit.
• The radio signal symbol flashes. The basic unit will scan for 3 minutes
the outdoor temperature.
• If the reception of outdoor temperature fails, "- -" appears on the
display. Check the batteries and try it again. Check if there is any
source of interference.
• Manual initialization can be helpful. Press and hold SEARCH button
on the backside of the basic unit for 3 seconds.
23