RIB RED Manual De Instrucciones página 20

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

G
B
POINT E
- RADIO EDGE RECEIVER
Once all connections are complete, switch on the power and make sure that the RADIO EDGE RECEIVER DL4 yellow led turns on.
POINT F
- TRANSMITTERS CODING
Each RADIO EDGE TRANSMITTER is supplied with all the identification
SW2 micro-switches turned off. This micro-switches configuration (all OFF)
permits to activate the sleep mode reducing the power consumption.
To enable the system, each transmitters MUST be identified from 1 to 6 by
turning ON one micro-switch. ONLY ONE micro-switch must be turned
ON and identification must be different for each transmitter.
IDENTIFY each transmitter by APPLYING THE SUPPLIED ADHESIVE
LABEL ON THE OUTSIDE OF EVERY PLASTIC CASE.
IDENTIFICATION IS REQUIRED FOR QUICK SELECTION OF
MALFUNCTIONING TRANSMITTERS, WHEN BATTERIES ARE TO BE
REPLACED IN WARNING OR ALARM STATE.
Per each RADIO EDGE TRANSMITTER identified, the same micro-
switch from 1 to 6 has to be turned ON on the RADIO EDGE
RECEIVER micro-switch.
SYSTEM CODING EXAMPLE WITH 1 RADIO EDGE TRANSMITTER
SYSTEM CODING EXAMPLE WITH 3 RADIO EDGE TRANSMITTER
RX
8
7
6
5
4
3
2
1
N.B. The bicolor orange led on the receiver will give confirmation intermittently blinks if dip switches on receiver are switched. By pushing PROG button,
new setting is accepted and programming mode is active. In order to avoid programming mode push 6 times PROG button, till bicolor leds are all
switched off.
RX
8
7
6
5
4
3
2
1
TX 1
ON
ON
TX 1
TX 2
6
5
4
3
2
1
20
20
20
20
1
2
3
4
5
6
1
2
3
4
5
6
6
5
4
3
2
1
TX 3
6
5
4
3
2
1
OFF
ON
6
5
4
3
2
1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Acg6202

Tabla de contenido