Esata Connection - Akasa elite Instrucciones De Instalación

eSATA CONNECTION

NOTE: Motherboard or adapter card with eSATA interface is required.
Connecting the Elite enclosure (eSATA mode)
1. Make sure the system is switched off.
2. Connect both Type A connectors of the USB-to-DC cable to any two available USB ports on
the PC or MAC. NOTE:
on HDD power consumption).
3. Connect the other end of the USB-to-DC cable into the DC 5V port of your 2.5" Elite enclosure.
4. Use supplied eSATA cable to connect the Elite enclosure to the motherboard's eSATA external
NOTE:
port. If the port is not present on your motherboard you may need to install an
eSATA adapter (eSATA-45-EX).
in some cases using single USB connector can be sufficient (depends
eSATA Connection
8