Hoover SteamVac Instruciones De Operacion página 3

1-2
Attach upper handle
Remove clean solution tank (upper
tank).
1-5
Place nuts in recessed areas on back
of handle. Hold each nut in place while
tightening each bolt securely with a
Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
1-8
Press cord into cord clip on back of
handle.
Pull cord tight.
1-3
With cord hook to back of cleaner, push
upper handle down onto lower handle.
1-6
When handle sections are completely
together, squeeze trigger (A) on upper
handle to snap trigger rod in place.
1-4
Push bolts into holes on front of handle.
If bolts will not go through hole easily
handle is not pushed completely down.
1-7
A
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
3