Specifications; Recommended Tools; Safety Precautions; Items Required For Operation - Maverick Vader XB Manual Del Usuario

Specifications

Length
Width
Height
Wheel base
Drive System
Gear Ratio
Ground Clearance
Diameter of wheel
Width of wheel
Motor
Servo
Receiver
Speed Control

Recommended Tools

These tools are not included with the product but are recommended for use whilst working with this vehicle
Scissors, Mini Screwdrivers, Hexagonal Screwdrivers 1.5mm, 2.0mm, 2.5mm, 3.0mm, 4-Way Cross Wrench (Small), 4-Way Cross Wrench
(Large), Side Cutters, Needle Nose Pliers

Safety precautions

This product is an authentic radio controlled vehicle (RC vehicle) and it is not a toy. Read and understand this instruction manual thoroughly
before running the model. If you are not familiar with RC vehicles, we recommend that you ask someone familiar with RC vehicles for advice.
Never connect the rechargeable drive battery in the reverse polarity or disassemble the battery. If the drive battery is used in the wrong way, high
current can be generated and it is very dangerous.
Never run RC models near people or animals, or on public streets or highways. This could cause serious accidents, personal injuries, and/or
property damage.

Items required for operation

4 * AA Batteries for the Transmitter

Charging the battery pack

This vehicle does not have any batteries or chargers included.
We recommend you using 2 x 3S (11.1V) LiPo Stick pack hard cased batteries with authentic Deans Connector installed. The connectors must be
a high current type as they will get very hot whilst in use, low current connectors may melt and cause failure and possibly fire.
Always follow the manufacturers guidelines for charging of both the battery and the charger. You cannot use a Ni-MH charger with LiPo batteries
and vice versa.
Cautions
•
Always follow charging guidelines from the manufacturer of the battery and the charger you have.
•
Always use good quality high current battery connectors, we recommend genuine Deans Connectors.
•
Do not use the charger or battery if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fire or burns.
710mm
450mm
276mm
503mm
4wd Shaft Drive
11.8:1
35mm
110mm
60mm
MM-27BL 980KV
MS-241 20KG
MRX-242 2.4GHz 4CH
MSC-27BL 150A Fwd/Rev
2